We program this QSFP-100G-LR4-LC with Juniper coding before shipping, at no extra cost. Your Juniper equipment (EX, QFX, MX, SRX, ACX) then sees it as its own optic, just like a JNP-QSFP-100G-LR4. Optically it's the same QSFP28 transceiver: 100GBASE-LR4, up to 10 km over OS2.
Junos usually doesn't block third-party modules, but lists them in 'show chassis hardware' without a Juniper part number, may raise an 'unsupported optics' alarm and can limit JTAC support for that port. With Juniper coding the module reports as a Juniper optic, including DOM readout via 'show interfaces diagnostics optics'.
Replaces these Juniper part numbers- JNP-QSFP-100G-LR4
- QSFP-100GBASE-LR4
Need another coding or generic (MSA)? All specs and codings are on QSFP-100G-LR4-LC transceiver
Compatible means: the same optical specs and Juniper coding, not an original Juniper product. Brand and part names belong to their owners and are shown for comparison.
The QSFP-100G-LR4-LC is a QSFP28 transceiver for 100GBASE-LR4: 100 Gb/s over single-mode fiber (OS2) up to 10 km, with LC duplex connector and DOM/DDM monitoring. Available generic (MSA) or pre-coded for 21 vendors, including Cisco, Juniper and Brocade: pick your equipment's vendor under Coding and we code it before shipping, at no extra cost. Tested, with test report and lifetime warranty.
Matching cable: OS2 LC-LC patch cable
Also known as: QSFP-100G-LR4-LC - QSFP28 100GBASE-LR4 - QSFP28 LR4 - 100G LR4 - 100G QSFP28 10 km
Same transceiver, pre-coded for your platform. Each vendor shows the original part number it replaces.