DAC, AOC or transceivers with fiber: which do you pick?

Short answer

Within the same rack, a DAC: copper, passive up to about 5 m, cheap and low-power. Up to a few racks away, an AOC (up to 10 m in our range). Longer, through a patch panel, or when you want to replace cable and optic separately: two transceivers with a fiber patch cord.

Updated November 20, 2026

Two devices need connecting and you're torn between a ready-made cable and separate optics. Distance almost always decides, then cost, power and how easily you can replace something later.

The three options side by side

DACAOCTransceivers + patch cord
Mediumcopper (twinax)fiber, optics fixed in the connectorfiber, separate optics
Typical reachup to approx. 5 m passiveup to 10 m (our 10G range)300 m multimode to 80 km and beyond
Power per endapprox. 0.1 W (passive)approx. 1 W (10G)approx. 1 W (10G SR)
Through a patch panelnonoyes
When it failsreplace the whole cablereplace the whole cablereplace only the broken part
Price (10G, 1 m, our range)lowestover twice a DAChighest

Power figures from Cisco and NVIDIA datasheets; the price order is our shop's at the time of writing.

How to choose

  • DAC — switch to server or switch to switch in the same rack. We supply DAC cables for SFP+ 10G (0.5 to 5 m), QSFP+ 40G (0.5 to 2 m) and QSFP28 100G (0.5 to 5 m).
  • AOC — to the next rack, or where a thick copper bundle blocks airflow. An AOC is thinner and lighter. We have AOCs for SFP+ 10G from 1 to 10 m.
  • Transceivers — anything that goes through a patch panel or cross-connect, is longer than 10 m, or where you want to swap the cable independently of the optics. For short multimode links that's an SFP-10G-SR at each end.

How long a DAC can be per speed is in how long can a DAC cable be. The full trade-off, with breakout and bend radius, is in DAC vs AOC vs optics.

More questions on this

Is a DAC a fiber cable?

No. DAC stands for Direct Attach Copper: twinax copper with a fixed SFP+ or QSFP housing at each end. An AOC is fiber, with the optics built into the connectors.

Does a DAC need coding?

Often, yes. A DAC identifies itself to the switch with a vendor ID, just like a transceiver. Our 40G and 100G DACs come with coding for your platform; if there are two vendors on the cable, tell us both.

Which uses less power?

A passive DAC draws about 0.1 W, just for the EEPROM. A 10G SR optic or a 10G AOC is around 1 W per end according to Cisco.

Related products and services

Further reading

Other questions