10G DAC cable: when to choose it
A DAC (direct attach copper) cable is a twinax cable with a fixed SFP+ connector at both ends. You need no optics and no patch cable: plug it into two SFP+ ports and you have a 10G link. For switch to switch or server to switch in the same rack it is the lowest-power, fastest and cheapest choice.
Length: 0.5 to 5 m
A passive 10G DAC works up to 5 m. We supply 0.5, 1, 2, 3 and 5 m. Don't pick it too long: an over-long DAC has to be coiled, and twinax is thicker and stiffer than fiber. Not sure of the length? Use the patch cable length calculator: enter rack, U position and route, and you get a length we supply.
DAC, AOC or optics?
- DAC: up to 5 m, draws about 0.1 W, practically no latency, lowest price.
- AOC: active optical cable, thinner and longer (we supply up to 10 m), a bit more expensive. See the AOC cables.
- Two optics with a patch cable: for anything longer than a few meters or between rooms. More expensive, but you replace cable and module separately.
Coding
A DAC identifies itself to the switch like a transceiver, with a vendor ID in its EEPROM. Switches from Cisco, Juniper, Arista and other vendors may reject an unknown cable or raise a warning. So pick your equipment's vendor under Coding. Connecting two different vendors, such as a Cisco switch to a server? Contact customer service and we'll work out which coding works at both ends.
Cable management in the rack
DAC cables are thicker than fiber. Don't bundle them tightly with cable ties; use hook-and-loop straps and let them run to the port in a wide curve. Label both ends, so during a fault you see at once which ports belong together. A DAC is one piece: if something goes wrong, you replace the whole cable. So keep one or two spares in the length you use most.



